Digital Watchdog DWC-D1363D922 Manuel d'instructions télécharger pdf (Page 18)

DAY & NIGHT

AUTO / In AUTO mode, camera switches between day and night automatically depending on light

COLOR / level. Camera will stay in color mode when there is enough light and will switch to B&W at

B&W night or other low light environments. If COLOR is selected, camera always stays in day/color

mode. If B&W is selected, camera always stays in night/B&W mode.

If AUTO is selected, please define the following settings:

*BURST: If ON is selected, the camera provides a color burst signal in night mode.

*COLOR->B&W: Adjusts the light level at which the camera switches from day (color) to night (B&W) mode. The higher the

*number, the lower the light level.

*B&W->COLOR: Adjusts the light level at which the camera switches from night (B&W) to day (color) mode. This number

*should be lower than the value of COLOR->B&W above.

*READ TIME: 3s~12s. Time interval delay before switching from day mode to night mode.

*EX_IR INT.: AUTO/EXT. If using IR LEDs built into the camera, select AUTO. If using external IR LEDs separately,

*select EXT.

NIGHT C.

0 ~ 100 Color will be reduced in low light conditions. (This level cannot be adjusted when

3D-DNR is ON.)

NIGHT A.

0 ~ 100 Edge sharpness will be reduced in low light conditions. (This level cannot be adjusted

when 3D-DNR is ON.)

EXIT JUMP

SAVE & EXIT Save the current settings and exit the OSD menu.

EXIT Exit the OSD menu without saving the changes.

D&N MODE

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

Pas de commentaire

Digital Watchdog DWC-D1363D922 Manuel d'instructions Page 18