Digital Watchdog x39 Manuel de service télécharger pdf (Page 60)

BIOS and System Programming

58 VIPA GmbH CP486 ⋅ 00/14

4.2 BIOS-SETUP

At the system startup the active terminal displays the BIOS version. First BIOS runs a test with

different system components and then a memory test. After test completion the system tries to boot

from the disk drive A, if existent, and then from disk drive C, if existent.

The SETUP can be invoked only during the system startup by pressing the <F2> key. This input

ensues as soon as the respective message is displayed on the screen. This is the case started with

BIOS version V18. Up to the BIOS version V17, the SETUP is invoked by concurrently pressing

"CTRL", "ALT" and "s" during system startup.

4.2.1 VIPA-BIOS-SETUP

First the VIPA-SETUP appears with the module series number (hexadecimal) and the fields

password input, bank parameterization and silicon disk selection. This window shows moreover a

system configuration (if battery is discharged) being lost. In the lower part of the screen are

displayed information about the key assignment for operating the SETUP:

(The text in brackets is the translation of the displayed!)

(VIPA-Setup for bank interface and silicon disk V0.3)

VIPA-Setup für Kachelinterface und Silikondisk V0.3

----------------------------------------------------------------------------------------------------

(Serial number of the module:)

Seriennummer der Baugruppe: 0305

(Change password:)

Passwort ändern:

(Current bank number:)

Aktuelle Kachelnummer: 32-39

(Disk drive A:)

Laufwerk A: FLOPPY-Disk

----------------------------------------------------------------------------------------------------

éê Cursor bewegen F5,F6 auswählen F10 übernehmen ESC Setup verlassen

Move Cursor) (Select) (Take over) (Leave setup)

A password (8 ASCII-characters) can be entered in the password-field of the SETUP. No password

is specified, as long as the SETUP-field is displayed as a white block. In this case you select other

SETUP options. A password is entered by an input of an ASCII-sequence up to 8 characters in the

password field, which has to be finished by pressing the ENTER key. As soon as a password is

entered the password field will not be displayed as a white but a black field. In this case the user can

enter the SETUP in order to change the password or resp. the system setup only if the stored

password is specified. If the ENTER key is pressed instead of entering an ASCII character in the

password field, the password will be deleted.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 189 190

Pas de commentaire

Digital Watchdog x39 Manuel de service Page 60