Digital Watchdog x39 Manuel de service télécharger pdf (Page 92)

Utility Software for MS-DOS

90 VIPA GmbH CP486 ⋅ 00/14

Then the base address is inquired where the silicon disk board is to be applied. This address is

entered as hexadecimal address:

Possible input values are: 800000

840000

880000

...

FC0000

Either the file contents generated with SDGEN or the contents of of a logical drive can be

transferred now to the silicon disk. If the contents of a file has to be transferred, the file name must

be entered. If the contents of a drive has to be transferred, only the drive label is specified.

File names are specified in the following format: [d:][path]file name

Drive labels are entered in the following format: d:

When specifying a file, this must have been generated with SDGEN in such a manner that the

complete drive contents is stored to only one file. The file is named then e.g.: SDISK.000

The drive to be programmed must have the same or larger capacity than the source file or the source

drive.

Attention:

SDLOAD copies the drive or the specified file without any changes. A drive being not bootable is

also non-bootable after it has been copied with SDLOAD. Concerning one case, a file must first be

created with SDGEN.

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 189 190

Pas de commentaire

Digital Watchdog x39 Manuel de service Page 92