Utility Software for MS-DOS
CP 486 ⋅ 00/14 VIPA GmbH 85
The corresponding driver is installed in the file CONFIG.SYS by the following command:
device=[d:][path]SDxxx.SYS [remark][/bb][remark][/llll][remark][/pp]
The particular parameters have the following function:
[c:][path] drive and path specification with driver SDxxx.SYS, whereby xxx
indicates the memory type being used for the silicon disk. The three
described drivers SDRAM, SDROM and SDPEROM are available.
[remark] optional text excluded the slash "/" and entry key
/bb base address of the silicon disk (step ratio = 64 kByte)
(e.g. /C0 corresponds to the physical start address C00000hex)
/llll capacity of the silicon disk (step ratio = 1 KByte)
(e.g. /256 corresponds to a disk capacity of 256 KByte = 262144 Byte)
/pp parameter for SDPEROM.SYS: block size of PEROMS
64 for AT29MC010 module
128 for AT29C010 and for AT29MC040 module
256 for AT29MC040 module
Examples:
Chip Silicon Disk with 1MB EPROM:
DEVICE = \DEVICE\sdrom.sys base address=/c0 size=/1024
Explanation: The driver is in the subdirectory "DEVICE" on the boot drive. The silicon disk
consists of a read-only memory. Therefore, the driver SDROM.SYS is taken. The
base address of the silicon disk lies at C00000H. The silicon disk has a capacity of
256 KByte.
Chip Silicon Disk with 256KB SRAM:
DEVICE = \DEVICE\sdram.sys base address=/c0 size=/256
Explanation: The driver is in the subdirectory "DEVICE" on the boot drive. The silicon disk
consists of a write-only memory. Therfore, the driver SDRAM.SYS is taken. The
base address of the silicon disk lies at C00000H. The silicon disk has a capacity of
1024 KByte = 1 MByte
Commentaires sur ces manuels